LUBA 2: mower ignores flower bed boundaries after an update

Models covered: LUBA 2
Last verified: 3 September 2026

Exact firmware version not confirmed. The source thread refers only to "the latest update," without stating a version string — we're documenting the report as-is rather than guessing which release it was.

What was reported

Posted 23 September 2024 on roboter-forum.com: after applying the latest firmware update at the time, a LUBA 2 owner reported the mower started mowing erratically and unpredictably. Previously it had reliably kept a safe distance from flower bed borders; after the update, it drove directly into flower beds instead. The owner made no configuration changes on their end and had to manually pull the mower out of the landscaping.

Why this is worth documenting even without a version number

This is close to the exact "update wrecked my lawn" scenario this site exists to document — a real, dated report of a firmware update degrading boundary-avoidance behavior with no user-side changes. If you're hitting similar erratic-boundary behavior after an update, this is a known prior report, even though we can't yet tell you the exact firmware version to roll back from or to.

If you can pin an exact firmware version to this behavior — either from your own experience or by finding it in the original thread — let us know so this page can carry real "rolling back from / to" version numbers instead of a general description.

Sources

roboter-forum.com: "Problem nach Update" (LUBA 2)